When you buy a used van, check the weight plate and the load area as carefully as the engine. A van’s working life is carried in its floor, its doors and its suspension, and the odometer on its own tells you less than it does on a car. Then check the paperwork: the V5C, the MOT history and mileage, finance, and whether the van has been stolen or written off. This checklist walks round the van in the order you’d actually do it.
It covers panel vans and small chassis-cab or crew vans up to 3,500kg. Bigger vehicles have different test and licence rules.
Before you go: five minutes at a screen
- Get the registration, mileage, MOT expiry and the number of owners from the seller, in writing if possible.
- Run the registration through a free vehicle check to confirm the make, model, colour, fuel and year match the advert. A van advertised as a different spec or colour than the record shows has been changed or misdescribed.
- Read the MOT history: mileage at each test, failures, advisories for corrosion, brakes and suspension.
- Check the tax status and, if the van is in a clean air zone or ULEZ area you work in, the ULEZ check.
- Decide what you need it to carry. Payload is the first spec you’ll check on the van itself.
Which MOT class is the van in?
GOV.UK puts vans up to 3,000kg design gross weight in class 4, with a maximum MOT fee of £54.85. Petrol, diesel and hybrid goods vehicles over 3,000kg up to 3,500kg are class 7, with a maximum fee of £58.60 (read at gov.uk, 20 Nov 2026). Fees are maximums and carry no VAT. The class matters because a heavier van is tested differently, and our class 7 MOT guide explains how.
Step 1: the weight plate and payload
Look for the plate or sticker on the van, often in the door shut or under the bonnet. GOV.UK says the maximum authorised mass, also called gross vehicle weight, is “normally shown on a plate or sticker fitted to the vehicle” (read at gov.uk, 20 Nov 2026). The plate may also show a gross train weight for towing.
The payload is the gap between the van’s unladen weight and its maximum weight, and it’s what you can legally put in it, including passengers, tools and fuel. Work out your usual load, add the weight of racking or shelving, and compare it. A van that’s close to its limit when empty-ish is a problem, because it’ll be over the line when full.
Check also that the plate’s details match the V5C and look original. A plate that’s been replaced, painted over or is missing needs an explanation.
Step 2: the load area
This is where a van’s story shows.
- Floor. Lift any mats or ply lining. Look for dents, cracks, rust and repairs. Heavy points of wear near the rear doors are normal; sagging or a patched floor isn’t.
- Bulkhead. Drilled holes, patched metal and weld marks suggest racking that has come out, or a partition that has moved.
- Side walls and ceiling. Dents from cargo, bent ribs and scuffs at shoulder height are signs of hard use.
- Tie-down points. Check that they’re present and intact.
- Doors. Open and close the rear and sliding doors fully. Binding, sagging or misalignment can mean the body has twisted.
- Smell and damp. Wet carpet or a musty smell can point to a leaking seal or roof.
Cosmetic wear is a matter of price. Rust in the structure, a repaired floor or a twisted body is a reason to walk away.
Step 3: signs of overloading
A van carrying too much, regularly, wears out faster. Look for:
- A rear end that sits lower than the front on a level surface, with the van empty.
- Cracked or sagging rear springs, or helper springs fitted without explanation.
- Uneven tyre wear on the rear axle, or tyres of different brands or types on the same axle.
- Worn rear shock absorbers and damper leaks.
- Damaged rear bump stops.
- Brakes that are worn unevenly, and a pedal that feels soft.
The signs aren’t proof of overloading, because worn suspension has other causes. Together with a heavy-duty history, they matter. The MOT advisories for suspension and tyres are the paper trail, and the MOT check shows them for every test.
Step 4: ex-courier, ex-tradesman or ex-rental?
A van that has done delivery rounds is stop-start work: clutches, brakes, sliding doors and the driver’s seat get the heaviest use. A tradesman’s van might have had racking fitted and removed, and carried heavy materials. A rental van has had many drivers.
The V5C shows how many keepers the van has had and whether the last one was a company. A company name is normal. Ask what the van did.
| Past use | What wears | Where to look |
|---|---|---|
| Courier or delivery | Clutch, brakes, doors, driver’s seat, suspension | Pedal rubbers, door runners, seat bolster, brake discs |
| Trades | Floor, bulkhead, paint, suspension | Holes in walls and floor, scuffs, rear springs |
| Rental | Bodywork, clutch, general abuse | Panel dents, kerbed wheels, clutch bite point |
| Light private use | Little, but may have been stored badly | Rust under the arches, perished rubbers |
Step 5: mileage
Vans cover more miles than cars, so a higher reading is normal. What matters is whether it’s genuine. Our research on 492,751 vehicles’ MOT histories (analysed 2 October 2026) puts the median at about 7,500 miles a year with vans included, and notes that vans run higher. The pattern across MOTs is the thing to read.
The mileage check lists the reading at each test in date order. Look for:
- A reading that falls from one test to the next.
- A year with almost no miles, then a sharp rise.
- A figure much lower than the wear in the cab suggests.
For vans of this size the odometer and the MOT record are your evidence, so read both.
Step 6: engine, gearbox and drive
- Start the engine cold. Listen for knocks, ticking and rattling; watch for smoke on startup.
- Check oil and coolant. Look for emulsion under the oil cap.
- Drive it: pulling away, gear changes, a clutch that bites at the top of its travel, noises from the transmission.
- Test the brakes: straight stops, no pulling or pulsing.
- Try it loaded if you can. A few bags of something heavy in the back show up suspension and clutch problems.
- Check the warning lights come on and go off. A dashboard lamp that doesn’t light at start-up may have been disabled.
Step 7: paperwork and history
GOV.UK’s checks for any used vehicle apply to vans: see the V5C, with a DVL watermark; check its serial number isn’t in the stolen ranges; match the VIN and engine number to the van; and tax it immediately after buying using the new keeper slip (read at gov.uk, 20 Nov 2026).
Then the record behind the paperwork:
- VIN check, to confirm the chassis number matches the V5C and the van.
- Finance check. Vans are often bought on finance, and the lender owns the van until it’s paid.
- Stolen check, since vans, tools and plates are theft targets.
- Write-off check for insurance total-loss records.
The free check covers MOT, tax and vehicle details; finance, write-off, stolen and keepers need the full report. See the sample report, the van check page and prices.
Running costs and rules to price in
Before you agree a price, add up what the van will cost in its first year: the next MOT at the class maximum above, tax, insurance for business use if that applies, tyres (vans wear rear tyres quickly when loaded), and any clean air zone charge on your routes. The car tax check shows the tax status of the van you’re looking at, and the ULEZ check tells you whether its emissions standard falls inside the rules in the areas you work. A cheaper van that fails the ULEZ test on the routes you drive costs more than a dearer one that doesn’t.
Used van checklist: print and tick
| Area | Check | Pass? |
|---|---|---|
| Plate | Present, original, matches V5C; payload suits your load | |
| Floor and walls | No rust, patching or twist | |
| Doors | Rear and sliding open and close squarely | |
| Rear springs, shocks, tyres | No sag, leaks or uneven wear | |
| Cab wear | Matches mileage | |
| MOT history | Mileage rises; no repeated corrosion advisories | |
| V5C | Watermark, VIN, engine number, keeper | |
| Record checks | Finance, stolen, write-off clear | |
| Drive | Clutch, brakes, steering, no warning lights |
Questions
What should I check when buying a used van?
The weight plate and payload, the load area floor and walls, the rear suspension, mileage against the MOT history, the V5C, and finance, stolen and write-off records.
How do I find a van’s payload?
Subtract the van’s unladen weight from the maximum authorised mass on its plate. Unladen weight is the van without passengers, goods or fuel, so ask the seller for the maker’s figure, or weigh the van, and remember that you, your tools and a full tank all come out of the payload.
Are high miles bad on a used van?
Not by themselves. Vans cover more than cars. Check that the mileage is steady in the MOT history and that the servicing matches it.
What MOT does a van need?
Vans up to 3,000kg design gross weight are class 4; petrol, diesel and hybrid goods vehicles from 3,000kg to 3,500kg are class 7.
How can I tell if a van was ex-courier?
Look at the keeper history, pedal and seat wear, door runners and brake condition, and ask the seller. The record gives you the keepers, not the job.
Can a van be bought on finance and still have finance owing?
Yes. A finance check shows outstanding finance against the registration.
Is it worth getting a van inspected?
For an expensive van, an independent inspection is worth the cost, along with a full history report.
Do I need a history check on a van?
Yes. A vehicle history check works on vans as it does on cars.